Moving the pod (optional)

Roll the carpet to the table-side of the pod. Remove all loose furniture if any present.
Warning: Risk of injury. Do not go into the pod when it is standing on the casters.
  1. Screw in the feet of the leveling screws (8 pcs) gradually with a 6 to 7 mm flathead screwdriver, so that the pod stands on the casters.
    Tip: If the leveling screws are stuck or tight, one person can push the pod from the corner closest to the foot that is being adjusted.
  2. Carefully push the pod to the new location.
    Note: Only push the pod below the vertical middle, do not tow it.
    Note: Only move the pod at walking speed.
    Note: Only move the pod on even surfaces. The pod can cross thresholds a maximum of 3 mm.
  3. Screw out the feet of the leveling screws (8 pcs) gradually with a 6 to 7 mm a flathead screwdriver.
    Make sure that the feet of the leveling screws are slightly past the casters and touch the floor. The feet are against the floor when you feel resistance.
    Tip: If the leveling screws are stuck or tight, one person can push the pod from the corner closest to the foot that is being adjusted.
  4. Level the floor and screw out the feet of the leveling screws to their final position. Measure the opposite points with a spirit level repeatedly and adjust the feet of the leveling screws gradually.
    Only screw the feet of the leveling screws outward to make sure that they stay past the casters.
  5. Roll out the carpet.
    Note: Make sure that the carpet is firmly installed and there are no bumps.