Install the roof body covers

  1. If you have installed the power cord from the ceiling, cut the notch out of the body cover.
    This is not necessary if you have installed the power cord to the floor module.
    Note: You only have to do this when installing for the first time.
  2. Guide the edge of one of the curved roof body covers into the groove at the edge of the roof.
    Note: Make sure that you install the cover correctly. The shorter straight section after the curve is installed to the edge of the roof.
  3. Guide the other edge of the body cover into the groove at the upper part of the wall.
  4. Repeat steps 2 and 3 to install the other curved roof body cover to the other side of the roof.
  5. Guide the edge of the straight roof body cover of the left-hand side into the groove at the center of the roof.
    Note: Make sure that the round circle in the body cover corresponds to the one in the roof.
  6. Guide the other edge of the body cover into the groove at the edge of the roof.
  7. Guide the edge of the straight roof body cover on the right-hand side into the groove at the center of the roof.
    Note: If you installed the power cord to roof module, guide the power cord out of the cut in the cover. Make sure that the cord is not damaged during the installation.
  8. Guide the other edge of the body cover into the groove at the edge of the roof.