Install the ramp

  1. Set the ramp board into place.
    Note: Make sure that the holes in the ramp board match the floor board connectors.
  2. Remove the protective sticker from the threshold.
    Note: The threshold has four screwholes.
  3. Install the threshold in the doorway with 3x12 screws (4 pcs).
    Note: Place the countersunk holes upwards.
    Note: Make sure that the side frame seals are not between the threshold and the door frame. Neatly cut the side frame seal to the correct length, if needed.
  4. Remove the protective papers from the stickers on the ramp board.
  5. Guide the ramp carpet under the threshold and press the carpet onto the stickers on the ramp board.
    Note: Make sure that the threshold secures the ramp carpet in place.
  6. Remove the protective sticker from the metal strips (3 pcs).
  7. Place the metal strip on the lower edge of the ramp board and push in place.
    Note: Make sure that you install the notches in the carpet against the side frames.
  8. Install the metal strips with M4x10 screws (11 pcs).