Install the table

  1. Install the base of the table leg with M6x20 countersunk screws (6 pcs) and 5x50 screws (4 pcs).
    Note: Make sure that the cords are not pinched or damaged during the installation.
  2. If installing the oval or wide table, install the table top to the table leg with 4.25x25 wronic screws (4 pcs).
    Note: Make sure that the table leg is attached in the correct position and that the cords are not pinched or damaged during the installation.
  3. If installing the turnable table, install the table top to the table leg with M5x10 cylinder head screws (4 pcs). Use the threads in the table top as reference.
  4. If the turnable table top feels too stiff or too loose, adjust the M6x20 screw.
    This only applies to the turnable table.
  5. If installing a wide table, install the installation brackets under the table top to the walls with 5x50 screws (1 pcs each).
    Note: Make sure that the distance from the glass to the back edge of the table top is equal over the entire width of the table. Measure the distance at the center and the ends of the table top.
    Note: Make sure that the table top is level. Use a spirit level.