Assemble the table

  1. Remove the rubber cover strip from the table leg.
  2. Remove the 4x20 screws and the small floor cover board.
  3. If not installing the optional LAN data cartridge continue to step 5. Pull the two LAN cords out of the hole in the floor.
  4. Lead the LAN cords from the floor through the base of the table leg.
  5. Set the base of the table leg into place.
    Note: Make sure that the notch at the base of the table leg is on the same side as the notch in the floor.
  6. If installing a wide table, install the table installation brackets with 5x25 screws (1 pcs each) under the table top.