Check that the CAN cord is connected to the power unit and control panel

Warning: Always disconnect the pod from the power outlet before you begin disassembly, maintenance, moving, or any other procedure.
  1. Remove the plug from the power outlet.
    If equipped with the optional LAN, also disconnect the LAN cord from the outlet.
  2. Remove the plastic trims and the wall body cover from the techwall.
  3. Remove the screws from the power unit cover and open the cover.
  4. Check the connection from the control unit to power unit.
    If he connection from the control unit to power unit is secure, continue troubleshooting and check the connection between the CAN cord and control panel.
  5. Disconnect the CAN cord.
  6. Disconnect the power outlet cord from the power unit.
  7. Remove the control panel screws.
  8. Remove the control panel from the opening in the techwall.
  9. Check that the CAN cord is securely connected to the control panel.
  10. Install the control panel to the opening in the techwall with the screws removed earlier.
  11. Connect the power outlet cord to the power unit.
  12. Remove and reconnect the GST cords to the vacant GST connectors in the power unit to check that the GST cord and the connectors are working.
  13. Connect the CAN cord to the power unit.
  14. Close the power unit cover and secure it with the screws removed earlier.
  15. Install the wall body cover and the plastic trims.
  16. Connect the power cord.
    If equipped with the optional LAN, also connect the LAN cord to an outlet.
  17. Reset the table. See Reset the table.