Change the door handedness

  1. Slightly lift the front frame with door and remove the door brace.
    Warning: Risk of injury and damage to property. Heavy object. Be very careful when lifting the front frame with door. Support the door glass so it cannot swing open uncontrollably. The door glass alone weighs approx. 55 kg (121 lbs).
  2. Remove the strut from the ball joint studs and set aside.
  3. Turn the hooks (1 pcs each) away from both hinges to release the springs.
  4. Lift the frame up onto the long edge.
    Note: Make sure that you support the frame continuously.
  5. Remove the protective caps (3 pcs each) from both hinges.
    Note: Do not use sharp tools to remove the caps. The frame scratches easily.
  6. Remove the screws (3 pcs each) from both hinges.
  7. Detach the frame from the door and turn the frame onto the floor next to the door.
  8. Remove and interchange the 5 mm (1/5 in) adjustment pieces and the 1 mm (1/15 in) adjustment pieces at both hinges.
    Install the adjustment pieces to the interchanged locations.
    Note: Make sure you interchange the adjustment pieces at both hinges.
  9. Remove the spacer from the hinge.
  10. Relocate the shoulder screw (1 pcs each) at both hinges. Do not overtighten the screws.
    Note: Make sure that you relocate the shoulder screw at both hinges.
  11. Install the spacer that was removed earlier to the other hinge.
    Note: Make sure that the spacer is installed to the opposite hinge that it was removed from.
  12. Turn the frame back up onto the long edge and connect it to the door.
    Note: Make sure that you support the frame continuously.
  13. Install the door to the hinges on the frame with the screws (6 pcs) removed earlier.
  14. Install the protective caps (6 pcs) removed earlier.
  15. Turn the frame down onto the door.
  16. Turn the hooks (1 pcs each) onto the hinges to engage the springs.
  17. Remove the ball joint studs from the frame.
  18. Install the ball joint studs to the opposite end of the frame. Do not overtighten the studs.
    The opposite end of the frame has plugs in the installation holes. Remove the plugs and install them to the installation holes left by the removed ball joint studs.
  19. Install the strut onto the ball joint studs.
  20. Slightly lift the front frame with the door and install the door brace.
    Warning: Risk of injury and damage to property. Heavy object. Be careful when lifting the front frame with door. The door glass alone weighs approx. 55 kg (121 lbs).
  21. Rotate the front frame with door 180°.
    Warning: Risk of injury and damage to property. Heavy object. Lift carefully. Lifting requires a minimum of 2 people. The front frame with door weighs approx. 86 kg (190 lbs)
    Note: Make sure that the hooks on the door frame are directly above the slots at the edge of the floor.
  22. Install the guide pin set aside earlier.
  23. Lift the front frame with door into place.
  24. Close the latches (6 pcs) around the front frame and install the pins (6 pcs).
    Note: Support the front frame with door until secured.
  25. Remove the door brace and install the door handles.
  26. Install all remaining parts in the reverse order.