Framery O Troubleshooting

Issue Cause Solution
Sound insulation
Door is leaking sound. Pod is not standing straight. Level the floor.
Door is too low. Raise the door.
Door seal is loose. Reinstall the door seal
Door is bent outwards from the top and bottom. Flip the bent door upside down
Power issues
No electricity in the pod. Pod power cord not connected. Check that the pod power cord is connected to a power outlet.
Pod power cord is connected to a faulty power outlet. Connect the pod power cord to another power outlet.
Power cord not connected to power unit. Check connection to power unit.
Tripped fuse. Reset the fuse
Power outlet not working. Power outlet cord not connected. Check connection to power unit.
Fans and light
Fans and light do not switch on. Faulty motion detector. See Diagnose a faulty motion sensor. Contact Framery Framery support for a replacement part.
Loose connections. Check connections inside the table.
DC cords are disconnected. Check the connection between the roof module and wall module DC cords
Light not working. Light cord not connected to control unit. Check connection to control unit. (inside the table)
Light's connections are loose. Check the light's electrical connections (pull out the light from the ceiling)
DC cords are disconnected. Check the connection between the roof module and wall module DC cords
Fans not working. Fan cord not connnected to control unit. Check connection to control unit. (inside the table)
Fan module's connections are loose. Check fan module's connections. (on the roof)
DC cords are disconnected. Check the connection between the roof module and wall module DC cords
Ventilation is at maximum level all the time. DC cord is broken. Contact Framery Framery support for a replacement part.
Noisy fans. Fan blades are obstructed. Check that fan blades can move freely.
Fan speed set to 100%. Reduce the fan speed.
Air inside the pod is not fresh. Pod is positioned in direct sunlight, under a heating duct, or close to some other heat source. Or, there is not enough space around or above the pod. See Operating space. Move the pod to another location.