Install the side glasses

Note: If the delivery includes the booking system bracket, go to step 3.
  1. Peel back the protective plastic approximately 100 mm (4 in) from the top and bottom of the aluminum frame of the strike plate-side glass.
  2. Guide the strike plate-side glass into the grooves and slide it into place.
    Note: Make sure that the control panel cord is not damaged during the installation. You can tape the cord to the aluminum frame to keep it out of the way.
    Note: Make sure that the strike plate-side glass with the strike plate is on the correct side for the door handing.
  3. Peel back the protective plastic approximately 100 mm (4 in) from the top and bottom of the aluminum frame of the hinge-side glass.
  4. Guide the hinge-side glass into the grooves and slide it into place.
    Note: Make sure that the aluminum profile of the glass is level with the corner frame.
  5. Check the straightness of the pod slightly below the roof and wall module junction with a spirit level.
  6. Install the screws on the glass frames first on the front half of the roof and then on the front half of the floor.
    Use M8x35 bolts (2 pcs) and M8 washers (2 pcs) on the roof and black M8x50 countersunk screws (2 pcs) on the floor.
    Note: Press the acoustic panel aside to reach the screw holes. Make sure that you return the acoustic panel to its original position.
    Note: Check with a spirit level that the hinge-side frame is straight. Push the pod if needed when installing the screws.