Install the roof body covers

  1. Install the roof body covers (2 pcs) in the center of the roof.
    Installation requires two people: One guides the cover from the ladder, one from the floor.
    Guide the cover first to the center of the roof. Then pull down and guide the lower edge to the groove on the wall.
  2. If you have installed the power cord from the roof, cut the notch out of the body cover.
    This is not necessary if you have installed the power cord to the floor module.
    Note: You only have to do this when installing for the first time.
  3. Install the roof body covers (2 pcs) to the left-hand back and right-hand front corners of the roof.
    Installation requires two people: One guides the cover from the ladders, one from the floor.
    Guide the cover first to the center of the roof and guide the edges of the covers against the flanges in the middle cover. Then pull down and guide the lower edge to the groove on the wall.
    Note: The covers for the right-hand front and left-hand back corners are identical, as are the covers for the left-hand front and right-hand back corners.
    Note: Do not lift the cover from the opening. The narrow metal strip bends.
  4. Install the roof body covers (2 pcs) to the left-hand front and right-hand back corners of the roof.
    Installation requires two people: One guides the cover from the ladder, one from the floor.
    Guide the cover first to the center of the roof and guide the edges of the covers against the flanges in the middle cover. Then pull down and guide the lower edge into the groove on the wall.
    Note: Do not lift the cover from the opening. The narrow metal strip bends.