Install the left-hand frames

  1. Install guide pins (8 pcs) to the installation holes.
  2. Install the lower center frame with black M8x50 countersunk screws (2 pcs).

    Install the screws from the inside of the pod.

    Note: When installing cords, pull the main power cord and one or two customer supplied LAN cords through the hole in the back half of the floor before installing the lower center frame.
    Note: Make sure that there is at least 2.75 m/9 ft (maximum 3.0/10 ft) of the main power cord inside the pod. You can pull the excess cord back outside the pod after the installation.
    Note: Make sure that the cords are placed in the notch in the lower center frame and that they are not not pinched.
  3. Install the lower corner frame of the left-hand side with black M8x50 countersunk screws (3 pcs).
    Note: The seismic support bracket is optional. The maximum size of the anchor bolt is M10. Follow the local regulations regarding seismic anchoring.
  4. Install the upper corner frame of the left-hand side with M8x55 bolts (3 pcs) and M8 washers (3 pcs).
    Note: Press the acoustic panel aside to reach the bolt holes. Make sure that you return the acoustic panel to its original position.
  5. Install the left-hand side frame with M8x55 bolts (3 pcs) and M8 washers (3 pcs).
    Tip: Use a clamp to straighten the frames if needed.