Install the metal box to the table top

  1. Lift the table top into the pod upside down.
    Note: Make sure that the ready-made holes are upwards.
  2. Install the cable holders with 3.5x16 screws (6 pcs) into the holes in the bottom of the table top.
    Note: Make sure that you remove the cover of the adhesive surface on the backside of the cable holders.
    Note: Make sure that you install the cable holders to the ready-made holes.
  3. Remove the M4x6 screw from the lid of the metal box.
  4. Open the lid of the metal box.
  5. Remove the platic inserts from the corners of the GST splitter baseplate.
  6. Tilt the metal box and push the plastic insert into the holes in the baseplate.
  7. Make sure that the ON/OFF switch of the power unit is in the "I" position.
    Note: If there is no ON/OFF switch, the power is always ON.
  8. Install the metal box with electrics to the bottom of the table top with 4x20 screws (4 pcs).
    The inserts in the baseplate guide the metal box to the correct place on the bottom of the table top.
    Note: Make sure that you install the metal box to the ready-made holes.
    Note: Make sure that the DC converter cord is on the wall-side of the table top.