Install the control panel (optional)
-
Insert the rubber cover to the U-profile on top of the strike plate-side glass frame.
-
Remove the plastic sticker over the holes for the control panel cord and screws on the
strike plate-side glass frame.
-
Install the control panel bracket on the strike plate-side glass frame with M4x10
screws (2 pcs).
-
Guide the control panel cord in through the hole in the middle of the strike plate-side glass
frame and out through the U-profile on top of the strike plate-side glass frame.
Note: Guide the flat (1x4 pins) end of the control panel cord in first.
-
Install the rubber grommet into the hole in the control panel case.
-
Install the magnets (2 pcs) behind the control panel with M4x10 screws (2 pcs). Use a
hand tool to tighten the screws.
-
Connect the control panel cord to the panel.
-
Install the control panel into the bracket.
Note: The control panel attaches to the bracket with magnets.Note: Make sure that the cord is not caught between the magnets and the case.