Install the combined roof and walls to the floor (back)

  1. Lift the combined roof and walls into place.
    Warning: Heavy object, risk of injury! Follow the regulations for safe lifting and pay attention to your posture. Lifting requires four people.
    Warning: Keep the installation area clear of obstacles that you may stumble over.
    Note: Make sure that the guide pin meets the installation hole in the wall module.
  2. Install M8x35 bolts (4 pcs each side) and M8 washers (4 pcs each side). Tighten the screws by hand.
  3. Remove the support beams and store them for later use.
    Warning: Do not go inside the pod before fully tightening the bolts after connecting the pod halves.