Check the straightness of the pod halves after connecting

  1. Check the straightness of the pod halves with a spirit level slightly below the roof and wall module junction in each corner of the pod.
  2. Push both halves of the pod at the same time slightly over vertical and hold.
    Note: Hold the pod in place continuously until all the bolts in the walls are fully tightened.
    Note: You need two people to tighten the bolts on both sides at the same time.
  3. Tighten the bolts (2 pcs) connecting the back and front halves of the pod in the floor and wall module junction.
    Tighten the bolts on both sides at the same time.
  4. Tighten the bolts (2 pcs) connecting the back and front halves of the pod in the middle of the wall module.
    Tighten the bolts on both sides at the same time.
  5. Tighten the bolts (2 pcs) connecting the back and front halves of the pod in the roof and wall module junction.
    Tighten the bolts on both sides at the same time.
  6. Tighten the bolts (2 pcs) connecting the back and front halves of the pod at the center of the roof from the inside of the pod.
  7. Tighten the bolts (4 pcs) connecting the back and front halves of the pod on the roof.
    Warning: Do not lean on the roof.
  8. Tighten the bolts (8 pcs per side) on the floor and wall module junction of the back and front halves of the pod.
    Tighten the bolts on both sides at the same time.
  9. Tighten the bolts (8 pcs per side) on the roof and wall module junction of the back and front halves of the pod.
    Tighten the bolts on both sides at the same time.
  10. Check the straightness of the pod with a spirit level slightly below the roof and wall module junction in each corner. If the pod is tilted, loosen the bolts and repeat the straightening procedure.